_________________________________________________________________________

Clutch Springs Installation
The tools you will need, long nose pliers, and a small flat screw driver:
1. Place the clutch down on a smooth solid surface, with the "C" clips facing upwards as in Fig 1.
2. Remove the "C" clips and remove the face plate see Fig 2.
3. Remove the clutch backing plate, be careful not to loose the small rubber stops, they will not be visible until you remove the backing plate, see Fig 3.
4. Remove the old springs, and install the new ones, see Fig 4.|
5. Replace the face plate, and re install the "C" clips see Fig 5.
Congratulations, you have adjusted installed the clutch springs!


Fig 1.

Fig 2.

Fig 3.

Fig 4.

Fig 5.

© copyright monsterGY6 2009